Monday 22 October 2007

Wedge-y Might

The sooner I fall behind, the more time I have to catch up.

I am now so far behind with blogging, that I don’t think I’ll ever catch up.

If I write posts for August, then I’m not writing posts for October. So I get further and further behind.


I am having so much fun on Ravelry, I don’t have time to blog.


There, I found Charisa’s gorgeous Wedge Hat and just had to try it. I started knitting it straight away!

I'm sure I didn't get it quite right. For example, I didn't know what size circumference I was aiming for at the welt. "plate" sizes vary so much! I think I may have been a bit timid on that.


I liked the way the colours knit up in this yarn - Cleckheaton Vintage Hues . It didn't seem to knit up as bulky as the one Charisa used. (Wouldn’t have any idea where to get Zitron Turmaline in Australia!) The recommended needles for this yarn are 6.5mm; I used 4mm to get the firm texture, It's such a dense fabric now, it feels almost like it's been felted. That's good - it hides all the holes!


The welt doesn't seem to have the same "presence" of Charisa’s welt; I wasn't sure if that was due to the difference in yarn thickness, or if it should have been more than just one row of purl. Or if I didn't go back far enough with the stitch pick-up.


I've blocked the top of the hat by putting a plastic picnic plate up in there, given it a light misting of spray water, and just left the brim unblocked. I rested it upside down on a towel for a while - now it's sitting on edge in front of the woodfire. The photos were taken before I blocked it. It should look more wedgey once the blocking is done.

I made the band longer so I could fold it over to give a chunkier brim.


The circumference of the welt at rest (unplated!) is 73cm (29 inches); and my head circumference (where I place hat-brims) is 56.5 cm (22 inches). I wonder if there's a magic ratio of welt:head which will make this work the best?


I learnt a lot doing this project.


I love the hat; but sad to say, I don't think it suits my head shape.



***********************

Update: I popped a bigger plate up into the hat last night, spritzed a bit more, left it to dry.


The photos are now the post-blocking ones. The top sits a little flatter with the stitches distributed better.

Then today I wore the hat out into town, and got two complimentary comments/questions about it!


I may well change my mind about this hat not suiting me!


PS: If you're an Aussie, you may get the pun in the message title ;-}

1 comment:

Lushorama said...

hehehehehe - I got the pun...!!!
Lovely hat!!!